Storage - Craftsman C950-52060-1 Owner's Manual

Storage

WARNING
Fuel and its vapors are extremely flammable
and explosive.
Fire or explosion can cause severe burns or
death.
When Storing Fuel or Equipment with Fuel in Tank
ÊÅÈ» ·Í·Ï ¼ÈÅà ¼ËÈÄ·¹»É ÉÊÅÌ»É Í·Ê»È ¾»·Ê»ÈÉ ÅÈ Åʾ»È
appliances that have pilot lights or ignition sources because
they can ignite fuel vapors.
Fuel System
Fuel can become stale when stored over 30 days. Stale fuel
causes acid and gum deposits to form in the fuel system
or on essential carburetor parts. To keep fuel fresh, use
Briggs & Stratton FRESH START® fuel stabilizer, available
as a liquid additive or a drip concentrate cartridge.
There is no need to drain the gasoline from the engine
if a fuel stabilizer is added according to the instructions.
Run the engine for 2 minutes to circulate the stabilizer
throughout the fuel system. The engine and fuel can be
stored up to 24 months.
If gasoline in the engine has not been treated with a fuel
stabilizer, it must be drained into an approved container.
Run the engine until it stops from lack of fuel. The use of a
fuel stabilizer in the storage container is recommended to
maintain freshness.
Engine Oil
While the engine is still warm, change the engine oil.
Snowthrower
1. Thoroughly clean the snowthrower.
˸ȿ¹·Ê» ·Â Â˸ȿ¹·Ê¿ÅÄ ÆÅ¿ÄÊÉ É»» ·ËʾÅȿлº º»·Â»È
3. Make sure all nuts, bolts, and screws are securely
fastened. Inspect all visible moving parts for damage,
breakage, and wear. Replace if necessary.
4. Touch up all rusted or chipped paint surfaces.
5. Cover the bare metal parts of the auger and impeller
with rust preventative.
6. If possible, store your snowthrower indoors and cover it
to protect from dust and dirt.
7. On models with folding handles, loosen the knobs that
secure the upper handle. Rotate the upper handle
forward.
8. If stored outdoors, place the snowthrower on blocks and
ensure the entire machine is off the ground. Cover the
snowthrower with a heavy tarpaulin.
en
»ÃÅÌ» ¼ÈÅà ÊÅÈ·½»
1. Raise the upper handle to the operating position and
tighten the knobs that secure the upper handle.
2. Fill the fuel tank with fresh fuel.
3. Check the spark plug. Make sure the gap is correct. If
the spark plug is worn or damaged, replace.
4. Make sure all fasteners are tight.
5. Make sure all guards, shields, and covers are in place.
Storage
21