Lexus 2015 RX350 Owner's Manual page 633

STEP 2
STEP 3
Repeat the steps above to program another device for each of
STEP 4
the remaining HomeLink
Press and hold one of the
HomeLink
mitter
HomeLink
changes from a slow to a rapid
flash, you can release both buttons.
If the HomeLink
comes on but does not flash, or
flashes rapidly for 2 seconds and
remains lit, the HomeLink
is already programmed. Use the
other buttons or follow the "Repro-
gramming a HomeLink
instructions. (P. 635)
Test the HomeLink
pressing the newly programmed
button.
If a HomeLink
programmed for a garage door,
check to see if the garage door
opens and closes. If the garage
door does not operate, see if your
remote control transmitter is of the
rolling code type. Press and hold
the programmed HomeLink
ton. The remote control transmitter
is of the rolling code type if the
HomeLink
rapidly for 2 seconds and then
remains lit. If your transmitter is of
the rolling code type, proceed to
the heading "Programming a roll-
ing code system".

buttons.
I n f o r ma t i o n P r o v i d e d b y :
3-7. Other interior features

buttons and the trans-
button. When

indicator

indicator light



operation by

button has been

indicator light flashes
the
light
button
button"
3

but-
633