Mercedes-Benz 2005 C 240 Operator's Manual page 255

Step 9:
Press "training" button on the garage
door opener motor head unit.
The "training light" is activated.
You have 30 seconds to initiate the
following step.
Step 10:
Firmly press, hold for two seconds and
release the programmed integrated
signal transmitter button (2, 3
or 4).
Step 11:
Press, hold for two seconds and
release same button a second time to
complete the training process.
Some garage door openers (or other rolling
code equipped devices) may require you to
perform this procedure a third time to
complete the training.
Step 12:
Confirm the garage door operation by
pressing the programmed integrated
signal transmitter button (2, 3
or 4).
Step 13:
To program the remaining two buttons,
repeat the steps above starting with
step 3.
Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to "time-out" (or quit)
after several seconds of transmission
which may not be long enough for the
integrated signal transmitter to pick up the
signal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to "time-out" in the same
manner.
Controls in detail
Useful features
If you live in Canada or if you are having
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4
with the following:
Step 4:
Continue to press and hold the
integrated signal transmitter button
(2, 3 or 4) while you press and
re-press ("cycle") your hand-held
remote control transmitter 6 every
two seconds until the frequency signal
has been learned. Upon successful
training, the indicator lamp 1 will
flash slowly and then rapidly after
several seconds.
Proceed with programming step 5 and
step 6 to complete.
253