Dmx Connections; Dmx Terminator - Elation Color Tone 50 User Instruction

Color Tone 50™
Be sure to follow the above figure when making your own cables. Do not use the ground lug
on the XLR connector. Do not connect the cable's shield conductor to the ground lug or
allow the shield conductor to come in contact with the XLR's outer casing. Grounding the
shield could cause a short circuit and erratic behavior.
DMX-512 connection with DMX terminator
A DMX terminator should be used in all DMX lines especially in longer runs. The use of a
terminator may avoid erratic behavior in your DMX line. A terminator is a 120 ohm 1/4 watt
resistor that is connected between pins 2 and 3 of a male XLR connector (DATA + and
DATA -). This fixture is inserted in the female XLR connector of the last fixture in your daisy
chain to terminate the line. Using a line terminator (Elation part: DMX T PACK) will decrease
the possibilities of erratic behavior.
©Elation Professional® 14 Color Tone 50™