Overheat Cut-Off Device - Baxi Solo 3 30 PF User Operating Instructions Manual

1
2
3
Fig. 4
*
Overheat Neon
Warning
Fig. 5
*
THERMOSTAT KNOB
Fig. 6

3.0 Overheat Cut-Off Device

3.1 Overheat Cut-Off Device
1. Your boiler is fitted with an additional safety
device which shuts down the appliance should the
system overheat. The "overheat" indicator light will
be illuminated if the appliance needs resetting.
NOTE: Any interruption to the electricity supply
may cause the device to operate. In the case of
persistant operation of the device, turn off the
boiler and consult your service engineer as an
appliance or system fault is indicated.
3.2 Resetting
1. To reset the device follow these instructions.
2. Allow the boiler to cool if hot.
3. Remove the lower door panel by following the
sequence of diagrams (Fig. 4).
5. Turn the boiler thermostat control knob fully
anti-clockwise to the OFF position marked '0'
(Fig. 5).
6. Wait 10 seconds.
7. Turn the control knob clockwise to the required
thermostat setting, the overheat light will go out
and the boiler will commence sparking and fire up
automatically when the boiler has sufficiently
cooled (Fig. 6).
8. No adjustments to the gas controls or boiler
thermostat are required.
5