Practical hints
Replacing bulbs
1 Protection cover
2 Electrical connector (parking and
standing lamps)
3 Electrical connector (high and low
beam)
282
4 Retainer spring
5 Bulb for high and low beam
6 Bulb socket for parking and standing
lamps
High and low beam bulb
Remove protection cover 1.
Pull off electrical connector 3.
Unclip retainer spring 4.
Remove bulb 5.
Insert new bulb so that the base lo-
cates in the recess on the holder.
Clip in retainer spring 4.
Plug electrical connector 3 onto
bulb 5.
Press on protection cover 1.
Parking and standing lamp bulb
Pull off electrical connector 2 from
bulb 6.
Push bulb 6 into socket, turn counter-
clockwise and remove.
Insert new bulb 6 in socket, push in
and turn clockwise until it clicks in.
Plug electrical connector 2 onto
bulb 6.