Mercedes-Benz 2002 M-Class Operator's Manual page 273

Instruments
Operation
and controls
Tires, Wheels
Using the wrench, tighten the five bolts evenly,
following the sequence illustrated, until all bolts are
tight. Observe a tightening torque of 110 ft.lb. (150 Nm).
Ensure proper tire pressure.
Instrument
Driving
cluster display
1
4
3
2
5
P40.10-2446-26
Practical hints Car care
270
Warning!
Always replace wheel bolts that are damaged or
rusted.
Never apply oil or grease to wheel bolts.
Damaged wheel hub threads should be repaired
immediately.
Incorrect mounting bolts or improperly tightened
mounting bolts can cause the wheel to come off.
This could cause an accident. Be sure to use the
correct mounting bolts.
Notes:
The removed road wheel cannot be stored in the
space-saver wheel carrier or inside the storage
compartment in the rear cargo area (ML 55 AMG), but
should be transported in the rear cargo compartment
wrapped in a protective cover supplied with the vehicle.
The protective cover is located in the rear cargo
compartment behind the cover in the right side trim
panel.
Model ML 55 AMG:
Store air pump in its proper location. Close and latch the
spare wheel cover, see page 261.
Technical
Index
data