HP t510 Hardware Reference Manual page 19

To remove the access panel:
1. Remove the secure compartment cover (1). For more information, see
Compartment Cover on page
2.
Remove the stand, if it is installed. See
3. Lay the unit flat on a stable surface with the right side up and the left side down.
4.
Slide the access panel about 3 mm (1/8 inch) toward the top of the unit (2), and then lift the
access panel up and off the unit (3).
Figure 2-3
Removing the side access panel
To remove the metal side cover:
NOTE: You must remove the metal side cover to access internal components such as the battery or
the memory.
1. Remove the four screws that secure the metal side cover to the chassis (1).
2.
Lift the metal side cover, rear side first, off the unit (2).
Figure 2-4
Removing the metal side cover
11.
Removing the Stand on page 6
Removing and Replacing the Side Access Panel and Metal Side Cover
Removing the Secure USB
for more information.
13