User Menus 221-1385; Setup Menu - Zenith B25A10Z Service Manuallines

USER MENUS 221-1385

SETUP MENU

Shown below is the Setup Menu for CA (A24) chassis
with its options for each item which are described as
follows:
Setup Menu
EZ Program
Add/Del/Surf
Clock Set
Captions
Caption/Text
Language
EZ PROGRAM
The EZ Program feature automatically searches for all
available channels and marks them as 'added' so that
they may be accessed via the channel Up/Down key.
In the EZ Program screen:
· A message at the top displays "EZ Program" to let the
customer know that he/she has entered the EZ Program
feature.
· A line at the bottom of the screen shows that the
Up/Down and Left/Right Arrow keys are used for Auto
Program selections.
· The current RF input type (Off Air Antenna or Cable
TV) is highlighted. Use the Up/Down Arrow keys to
change the RF input type.
To start the Auto Program, press the Left/Right Arrow
key. If the Cable TV input type is selected, the EZ Program
routine will determine what type of cable system is
present.
Notes:
•
EZ Program clears all Surfing channels which were
added.
•
While searching for channels, all keys except for
the Power key are disabled. This prevents an
incomplete EZ Program procedure.
•
Running the EZ Program will clear the factory
mode, if it was active. This happens at the end of
the EZ Program.
•
If the EZ Program line in the Setup Menu is 'red',
this indicates that the module did not pass one of
the test equipment's tests.
CM151
USER MENUS 221-1385
To Program
1-15
•
If no channels are found then the following
message will appear: "Make sure that the cable/
ant. is connected, and try again."
CHANNEL Add/Del/Surf
After running the EZ Program, all channels found by the
EZ Program feature will be marked 'Added'. However, some
of these channels may be scrambled, or undesired by
the customer. The Add/Del/Surf feature allows the
customer to selectively mark any channel as 'Deleted' or
'Added'.
To change the status of a channel, press the Right/Left
Arrow key.
To change the channel while adding or deleting
channels, use the Channel Up/Down keys, or press the
desired channel digits, followed by 'Enter'. If Channel
Up/Down is pressed, the next or previous channel which
was marked 'Added' will appear. If only one channel is
present, to change the channel the customer must use
the digit key pad to select a channel.
CLOCK SET
When no time is set, the display shows: —:— —
There are two ways to set the time:
1. Direct Entry (preferred) Use the digit keys, followed
by 'Enter' or Select Up/Down.
2. Left/Right Arrow keys
When the first digit is introduced, the display shows:
—:-d AM
When the time is set, the display shows:
hh:mm AM
where:
d = digit, mm = minutes hh = hours
Entering an invalid time ("0" for example) will result in
the clearing of the current time (—:— —). Also when
only one digit is pressed and no other is pressed in an
interval of seven seconds, the current time will be cleared.
Note: When the first digit is pressed (or the Left/
Right Arrow Key is pressed), a TIMER icon
appears on the right side of the AM/PM status.
The Left/Right Arrow keys is the other way of setting
the time. The drawback with using the Left/Right Arrow
keys is if the customer uses the Right Arrow key, the
time will increment to the next minute and so on until
the customer finds the time desired. On the other hand,
if the Left Arrow key is pressed, the time will decrement
one minute and so on until the customer finds the time
desired.
< FLSHBK
< FLSHBK
CA - 1385 MENUS