Uart Mode Select; Onboard Parallel Port; Parallel Port Mode - Gigabyte GA-8PENXP User Manual

UART Mode Select

This item allow s y ou to determine w hich Infra Red(IR) function of Onboard I/O chip.
ASKIR
IrDA
Normal
UR2 Dupl ex Mode
This feature allow s y ou to sec lect IR mode.
This function w ill av ailable w hen "UART Mode Select" doesn't set at Normal.
Half
Full

Onboard Parallel port

This feature allow s y ou to select from a giv en set of parameters if the parallel port uses the onboard
I/O controller.
Disabled
378/ IRQ7
278/ IRQ5
3BC/ IRQ7

Parallel Port Mode

This feature allow s y ou to connect w ith an adv anc ed printer v ia the port mode it supports.
SPP
EPP
ECP
ECP+EPP
ECP Mode Use DMA
This feature allow s y ou to select Direc t Memory Access (DMA) channel if the ECP mode s elected.
This function w ill av ailable w hen "Parallel Port Mode" set at ECP or ECP+EPP.
3
1
8penxp_1001_b.p65
Set onboard I/O chip UART to ASKIR Mode.
Set onboard I/O chip UAR T to IrDA Mode.
Set onboard I/O chip UAR T to Norm al Mode. (Default Value)
IR Function Duplex Half. (Default Value)
IR F unction Duplex F ull.
Disable onboard LPT port.
Enable onboard LPT port and address is 378/IRQ7. (Default Value)
Enable onboard LPT port and address is 278/ IRQ5.
Enable onboard LPT port and address is 3BC/ IRQ7.
Using Parallel port as Standard Parallel Port. (Default Value)
Using Parallel port as Enhanced Parallel Port.
Using Parallel port as Ex tended Capabilities Port.
Using Parallel port as ECP & EPP mode.
Set ECP Mode Use DMA to 3. (Default Value)
Set ECP Mode Use DMA to 1.
- 51 -
51
BIOS Setup
2003/4/11, 下午 03:59