Troubleshooting - Contour CoreBelt Use & Care Manual

troubleshooting

Problem Possible Cause
I am not feeling Gel Pad not directly against
anything your clean, dry skin
Intensity level might not be
high enough
Gel Pads may not be
properly positioned
The Lead-Wire module is
not inserted correctly
I pressed power The batteries are inserted
and the device improperly
doesn't turn on
The batteries are dead
Display is on but The device is paused
there is no signal
The Lead-Wire module is
not inserted correctly
The Lead-wire(s) may not
be connected to the Gel
Pads
Gel pad electrodes are
not making contact with
your skin
The battery The batteries are low
symbol is flashing
The contractions The batteries are low
are weak even
though the
intensity is high
The Gel Pads have
lost conductivity
The pads are positioned
improperly
Solution
Make sure the plastic liner is removed from
your gel pad electrode and place it (BLACK
SIDE) directly against your clean, dry skin.
The intensity must be at least 15% before
you will feel anything.
Turn the M2 device off, remove the Core-
belt and reposition as described in this
™
manual. Make sure the Gel Pads are below
your rib cage.
Make sure the wires are securely attached
Replace batteries in proper position as
shown on the set-up pages
Replace all 4 AAA batteries
Never mix old and new batteries
Press On/Off button
Slide the Lead-Wire module onto groves
of the M2 device until you hear it click
into place
Turn the M2 device off and insert the
pin-end of the electronic module wire into
the wire from the Gel Pad
Make sure the black side of the gel pad
electrode is making good contact wIth your
clean, dry skin
Replace all 4 AAA batteries.
Never mix old and new batteries
Replace all 4 AAA batteries.
Never mix old and new batteries
Replace Gel Pads
Turn the M2 device off, remove the Core-
belt and reposition as described in this
™
manual. Make sure the Gel Pads are below
your rib cage.
26
Problem Possible Cause
Stimulation is The Gel Pads may
uncomfortable be worn out
Intensity level might be set
too high
Gel Pads may not
be properly positioned
Too many sessions in a row
My muscles are Intensity level might be set
sore after using the too high
Contour CoreBelt ™
I feel tingling in Gel Pads are located near a
my legs nerve center
I just bought the Your diet plays a vital
Contour but I'm not role. Are you following the
seeing results Contour diet plan?
The intensity level might not
be set high enough
Solution
Replace Gel Pads
Reduce the intensity level until your body
gets used to it.
Turn the M2 device off, remove the
Corebelt and reposition as described in
™
this manual. Make sure the Gel Pads are
below your rib cage
Leave at least six hours between
sessions
Reduce the intensity level
Move the Gel Pads slightly
Follow the eating plan in the Diet and
Exercise Guide
Increase the intensity level.
You should see results in 2-3 weeks
27