Schumacher XP2260 Owner's Manual page 12

11.5 Using the Built-In Light
1. Position the Instant Power™ on a flat, stable surface near the intended work area.
2. Ensure the battery clips are securely clipped on the storage holders.
3. Press the Light Switch to the ON position.
4. The Instant Power™ light will turn on and illuminate your work area.
5. Press the Light Switch to the OFF position.
6. Charge the Instant Power™ as soon as possible after using the built-in light.
11.6 Using the Air Compressor
RISK OF EXPLOSION.
Read the instructions of the product being inflated before using the compressor.
Avoid over inflation, do not exceed the manufacturer's recommended pressures.
Do not leave the air compressor unattended during use.
1. Ensure the battery clips are securely on the storage holders.
2. Remove the air compressor hose from the storage compartment in the back of the
Instant Power™. Install adapters as necessary.
3. Attach the air compressor hose to the product or accessory to be inflated.
4. Place the Compressor/Inflator Switch in the COMPRESSOR position and inflate the
product.
5. When the product is inflated to the proper air pressure (using the air compressor
gauge) place the Compressor/Inflator Switch in the OFF position and remove the
hose.
6. Do not run for more than 10 minutes maximum at a time. Allow the Instant Power™
to cool down for 10 minutes before using again.
NOTE: To prevent overheating, the compressor has built-in thermal protection that
will turn the compressor off before it overheats. If the compressor shuts off, wait a few
minutes and it will automatically restart when the compressor cools.
NOTE: The air compressor is rated for 150 PSI.
vehicle Tires 13" to 16"
Bike Tire
Sports Balls
These times are approximate. Use the air compressor gauge to ensure the proper
pressure has been reached. Do not over inflate.
11.7 Using the Inflator
RISK OF EXPLOSION.
Read instructions of the product being inflated before using the inflator. Avoid
over inflation, do not exceed the manufacturer's recommended pressures. Do
not leave the inflator unattended during use.
1. Ensure the battery clips are securely on the storage holders.
2. Attach the corrugated hose with end adapter to the high-flow inflator outlet located
near the Compressor/Inflator switch on the back of the Instant Power™.
3. The main accessory adapter attached to the corrugated hose accommodates up to 4
sizes. If another size is needed, an additional adapter can be attached to the end of
the main accessory adapter.
4. Insert the adapter into the product to be inflated.
5.
Push the Compressor/Inflator switch to the INFLATOR position and inflate the
product.
Estimated Time for Inflating
6 to 24 minutes
1 to 3 minutes
30 seconds
8
• •