Schumacher XP2260 Owner's Manual page 11

8. Turn ON the Jump Start ON/OFF switch. Crank the engine. If the engine does not
start within 5-8 seconds, stop cranking and wait at least 1 minute before attempting
to start the vehicle again. (This permits the battery to cool down.)
9. After the engine starts, make sure to turn OFF the Jump Start switch.
Then, disconnect the black clip (-) and then the red clip (+) in that order.
10. Recharge the Instant Power™ as soon as possible after use.
RISK OF EXPLOSION.
To prevent sparking, NEvER allow the clips to touch together or to contact the
same piece of metal. Never attempt to jump start a frozen battery.
11.3 Powering a 12V DC Device:
The Instant Power™ is a power source for all 12v DC accessories that are equipped
with a 12V accessory plug. Use it for power outages and fishing or camping trips.
Estimated usage time is listed in the chart below.
Make sure the device to be powered is OFF before inserting the 12v DC accessory plug
into the 12v DC accessory outlet.
1.
Ensure the battery clips are securely clipped on the storage holders.
2.
Open the protective cover of the DC power outlet on the front of the Instant Power™.
3.
Plug the 12v DC device into the DC power outlet, and turn the 12v DC device on
(if required).
4. If the 12v DC device draws more than 15A or has a short circuit, the internal circuit
breaker of the Instant Power™ will trip and disconnect the power to the device.
Disconnect the 12v DC device. The breaker will automatically reset after an overload
occurs.
The DC power outlet is wired directly to the internal battery. Extended operation of a 12v
DC device may result in excessive battery drain. Recharge immediately after unplugging
the 12v DC device.
Appliance Type
Cell Phone
Fluorescent Light
Radio, Fan
Depth Finder
Camcorder, vCR
Electrical Tool
Electrical Cooler
Car vacuum, Air Compressor
NOTE: Estimated run-times. Actual time may vary. Times are based on the internal
battery being fully charged and in good condition.
11.4 Using the USB Port
The USB port provides up to 500mA at 5v DC.
1.
Ensure the battery clips are securely clipped on the storage holders.
2.
Turn the Instant Power™ On/Off switch to the ON position.
3. Plug in and turn the USB device on.
4. Reverse these steps when finished using the USB port.
5. Charge the Instant Power™ as soon as possible after using the USB port.
Estimated Wattage
4 watts
4 watts
9 watts
9 watts
15 watts
24 watts
48 watts
80 watts
7
• •
Estimated Usage Time
66 hours
66 hours
29.3 hours
29.3 hours
17.6 hours
11 hours
5.5 hours
3.3 hours