Campbell Hausfeld PW2120 Product Manual page 4

Pressure Washers
Pre-Operation
UNPACKING
Remove the equipment and all parts
from the carton. The carton should
contain the following.
• One pressure washer (pump,
engine, cart base).
• One cart handle assembly.
• One basket (not included with all
models).
• One front guard tube (not included
with all models)
• One detergent tank.
• One spray gun.
• One lance with nozzle.
• Spray tips (not included with all
models).
• One high pressure hose.
• One pack of nuts, bolts, and
manuals.
• One bottle of engine oil.
If any parts are missing, DO NOT
RETURN THE UNIT TO THE RETAILER.
Know the unit's model number (locat-
ed on the serial number tag on the
pressure washer frame) and call 1-800-
330-0712 for replacement parts.
After unpacking the product, inspect it
carefully for any damage that may
have occurred during transit. Make
sure to tighten fittings and bolts
before using the pressure washer.
Do not operate the
WARNING
!
unit if it's damaged
during shipping, handling, or use.
Damage could result in bursting and
cause injury or property damage.
ASSEMBLY
You will need 7/16" and 3/8" wrenches,
and pliers, to assemble.
1. Slide the handle assembly over the
lower legs of the cart base. Use the
standard nut and bolt to secure the
right rear leg. See Figure 1.
Figure 1 - Assemble Handle
www.chpower.com
2. An eyelet bolt is included with some
models to secure the engine pull
cord. Use this bolt and nut to secure
the rear leg. Be sure to pull the
starter cord through before tighten-
ing the bolt. See Figure 2.
Figure 2 -Secure engine pull cord
3. Attach detergent tank to handle with
the 4 hex bolts and 4 nuts provided.
4. Slide clear plastic hose attached to leg
onto black plastic hose barb of deter-
gent tank (See Figure 3).
Figure 3 - Attach suction tube to barb
fitting
5. If applicable: attach front guard
tube to base plate with the 4 bolts,
4 washers and 4 nuts provided (See
Figure 4).
Fasten to baseplate
Figure 4 - Attach front guard tube (if
applicable)
4
6. If applicable: attach wire basket to
front guard by pressing the hooks
of the basket over the tube. Then
align front eyelets of basket with
front holes of front guard tube.
Fasten with the 2 bolts, 4 washers,
and 2 nuts provided (See Figure 5).
Snap down over tube
Fasten with bolts
Figure 5 - Attach basket (if applicable)
7. Secure garden hose (not included)
to the inlet connection on pump.
(See Figure 6.)
Figure 6 - Secure garden hose
8. Connect the high pressure hose to the
pump outlet (See Figures 7 and 8).
Figure 7 - Connect high pressure hose
to pump