Table of Contents
Advertisement
11.4.19
Replacement of Interior Lamp
1.
Disconnect the refrigerator from the power supply.
2.
Remove the light cover. (This can be done by using a small screwdriver and levering the cover
off the front clips.)
3.
The faulty light bulb is removed by pulling the bulb out of the light socket.
4.
To replace the light bulb, cut the plastic bag but do NOT touch the bulb with your fingers.
5.
Push the bulb into position.
6.
Reconnect the refrigerator to the power supply.
7.
Ensure the light operates and refit the light cover.
11.4.20
Replacement of the interior light socket
The interior light fitting, while foamed into the roof of the provision compartment, can be replaced
by the following steps
Steps:
1.
Remove the lens cover.
2.
Remove the lamp.
3.
Drill three 5mm holes in the lamp housing in the positions shown above. This will cut off the
tabs holding the light socket to the liner.
Diagram 11.4.19
57
321037
Hide quick links:
Advertisement
Table of Contents
