DFI-ITOX G7V300-P User Manual page 53

Chassis Open Connector
The system board supports the chassis intrusion detection function.
To use this function, connect the chassis intrusion sensor cable from
the chassis to the chassis open connector. Whenever a chassis
component has been removed, the sensor sends signal to the
connector alerting you of a chassis intrusion event. To disable this
function, place a jumper cap over the connector.
Hardware Doctor Utility
Install "Hardware Monitor for Windows". By default, the chassis
intrusion detection function is disabled. When enabled, a warning
message will appear when the chassis is open. The utility can also be
configured so that a beeping alarm will sound when the chassis is
open. Refer to the "Hardware Monitor for Windows" section in
chapter 4 for more information.
Hardware Installation
1
Ground
2
Chassis
signal
2
53