Removing The Monitor Stand; Mounting The Monitor - HP HWP018107 User Manual

Removing the monitor stand

You can remove the monitor panel from the stand to install the panel on a wall, a swing arm, or other
mounting fixture.
CAUTION:
and signal cables are both disconnected.
1. Disconnect and remove the signal and power cables from the monitor.
2. Lay the monitor face down on a flat surface covered by a clean, dry cloth.
3. Press down on the release latch (1) with a screwdriver and slide the stand out of the slot on the display
head (2).

Mounting the monitor

The monitor panel can be attached to a wall, swing arm, or other mounting fixture.
NOTE: This apparatus is intended to be supported by UL or CSA Listed wall mount bracket.
1. Remove the stand from the monitor. See
CAUTION:
third-party mounting solution to the monitor, four 4 mm, 0.7 pitch, and 10 mm long screws are
required. Longer screws must not be used because they may damage the monitor. It is important to
verify that the manufacturer's mounting solution is compliant with the VESA standard and is rated to
support the weight of the monitor display panel. For best performance, it is important to use the power
and video cables provided with the monitor.
2. Remove the VESA cover from the back of the monitor.
a. Insert tools or fingers in the two slots in the bottom edge of the VESA panel.
b. Pull the bottom edge of the VESA panel up and off the display.
14 Chapter 3 Setting up the monitor
Before beginning to disassemble the monitor, be sure the monitor is turned off and the power
This monitor supports the VESA industry standard 100 mm mounting holes. To attach a
Removing the monitor stand on page 14.