Connection; Connecting The Dvd To A Tv And Catv Using He Rf Input/Output Jacks - Memorex MVDR2100 User Manual

CONNECTING THE DVD TO A TV AND CATV USING THE RF INPUT/OUTPUT JACKS
IMPORTANT:
This will only send the
cable/satellite signal to
the TV. To play a disc,
you must connect using
the A/V, S-Video or
component outputs as
described on the
following pages.
Coaxial Cable (Not Included)
From Source (i.e. cable, etc.)
NOTES FOR CONNECTING TO CATV, SATELLITE, ETC.
• The signal will be sent to the TV regardless if the DVD recorder is on or off.
• If your TV has a Component input, connect the DVD recorder with the component cable for best
results, otherwise use the S-Video or Video Out jack(s) on the DVD recorder.
• You can use the DVD recorders tuner to change channels, or you can use your TV's tuner.
• When connecting the DVD, refer to the owner's manual of the TV, as well as this manual.
• When connecting the DVD to the TV, make sure the power is off and both units are unplugged
before making any connections.
• Connect the DVD recorder to your TV directly. If you connect the DVD recorder through a VCR, the
playback picture will be distorted because DVD video discs are copy protected.
• Connect a cable, etc. signal as described on this page to use the tuner capabilities of this unit and
one of the OUT video connections on the CONNECTION pages to play a disc. If your TV only has
an RF input, then an RF Modulator Accessory RF-150 will be required.
• After connecting, press the SOURCE button to select TV, "CH" and a channel number will appear on
the TV.

CONNECTION

Coaxial Cable (Not Included)
From
RF Out
To RF IN
9
To
RF IN