Controls - Cub Cadet 900 series Operator's Manual

Controls and Features
Drift Cutters
(optional)
Now that you have set up your snowthrower for operation, get
acquainted with its controls and features. These are described
below and illustrated on this page. This knowledge will allow you
to use your new equipment to its fullest potential.
NOTE: For detailed starting instructions and more information
on all engine controls, refer to the separate engine manual
packed with your unit.
Speed Selector Lever
The speed selector lever is located on the handle
panel and is used to determine ground speed and
direction of travel.
Forward
There are six forward (F) speeds. Position one (1) is
the slowest and position six (6) is the fastest.
Reverse
There are two reverse (R) speeds. One (R1) is the
slower and two (R2) is the faster.
12
Chute
Assembly
Clean-Out
Tool
Augers
Figure 4-1
Drive Control
Skid Shoe
Augers
When engaged, the augers rotate and draw snow into the auger
housing.
Chute Assembly
Snow drawn into the auger housing is discharged out the chute
assembly.
Skid Shoes
Position the skid shoes based on surface conditions. Adjust
upward for hard-packed snow. Adjust downward when
operating on gravel or crushed rock surfaces.
Headlight (if so equipped)
The headlight is on whenever the engine is running.
Drift Cutters (if so equipped)
The drift cutters are designed for use in deep snow. Their use
is optional for normal snow conditions. Maneuver the snow
thrower so that the cutters penetrate a high standing snow drift
to assist snow falling into the augers for throwing.
4
Shift Lever
Two-Way Chute Control™
(optional)
Auger Control
Wheel Steering Control
Chute Directional
Control