Asus Pentium TX97-E User Manual page 29

III. INSTALLATION
7. Primary / Secondary IDE connectors (Two 40-pin Block)
These connectors support the provided IDE hard disk ribbon cable. After con-
necting the single end to the board, connect the two plugs at the other end to
your hard disk(s). If you install two hard disks, you must configure the second
drive to Slave mode by setting its jumper accordingly. Please refer to the docu-
mentation of your hard disk for the jumper settings. BIOS now supports SCSI
device or IDE CD-ROM bootup (see "HDD Sequence SCSI/IDE First" & "Boot
Sequence" in the BIOS Features Setup of the BIOS SOFTWARE) (Pin 20 is
removed to prevent inserting in the wrong orientation when using ribbon
cables with pin 20 plugged).
TIP: You may configure two hard disks to be both Masters using one ribbon
cable on the primary IDE connector and another ribbon cable on the secondary
IDE connector. You may install one operating system on an IDE drive and
another on a SCSI drive and select the boot disk through BIOS Features Setup.
IDE (Hard Drive) Connectors
8. IDE activity LED (IDE LED)
This connector supplies power to the cabinet's IDE activity LED. Read and
write activity by devices connected to the Primary or Secondary IDE connectors
will cause the LED to light up.
IDE (Hard Drive) LED Lead
Pin 1
Connect the Red stripe to Pin 1
Secondary IDE Connector
Primary IDE Connector
TIP: If the case-mounted LED does not light,
try reversing the 2-Pin plug.
IDE LED
ASUS TX97-E User's Manual 29