Ford 2013 Flex Owner's Manual page 326

Hide thumbs Also See for 2013 Flex:

Table of Contents

Replacing headlamp bulbs

WARNING: Handle a halogen headlamp bulb carefully and keep

out of children's reach. Grasp the bulb only by its plastic base and

do not touch the glass. The oil from your hand could cause the bulb to

break the next time the headlamps are operated.

Note: If the bulb is accidentally touched, it should be cleaned with

rubbing alcohol before being used.

1. Make sure headlamp switch is in the off position, then open the hood.

2. Reach in behind the headlamp assembly to access the bulb sockets

and connectors.

3. Locate the high beam/low beam headlamp bulb electrical connector

and remove it by squeezing the locking tab and pulling it straight out.

Install the new bulb(s) in reverse order.

Replacing HID headlamp bulbs (if equipped)

The headlamps on your vehicle use a "high intensity discharge" source.

These lamps operate at a high voltage. When the bulb is burned out, the

bulb and starter capsule assembly must be replaced by your authorized

2013 Flex (471)

Owners Guide gf, 1st Printing

4. Remove the bulb socket by

turning it counterclockwise and

pulling it straight out.

I n f o r ma t i o n P r o v i d e d b y :