Ford 2013 Flex Owner's Manual page 186

186 Universal Garage Door Opener
Erasing the Function Button Codes
Reprogramming a single button
To program a device to a previously trained button, follow these steps:
1. Press and hold the desired button. Do NOT release the button.
2. The indicator light will begin to flash after 20 seconds. Without
releasing the button, follow Step 1 in the Programming section.
For questions or comments, contact HomeLink at www.homelink.com or
1-800-355-3515.
Programming HomeLink to a Genie Intellicode 2 garage door
opener
Note: The Genie Intellicode 2 transmitter must already be programmed
to operate with the garage door opener.
Programing the transmitters
To program HomeLink to the transmitter you must first put the
transmitter into programming mode. To do this
A
1. Press and hold one of the buttons on the transmitter for 10 seconds.
The LED light will change from green to green and red.
2013 Flex (471)
Owners Guide gf, 1st Printing
USA (fus)
Note: You can not erase individual
buttons.
1. Press and hold the outer two
function buttons simultaneously for
approximately 20 seconds until the
indicator lights above the buttons
flash rapidly.
2. When the indicator lights flash,
release the buttons. The codes for
all buttons are erased.
A. Red LED
B. Green LED
B
I n f o r ma t i o n P r o v i d e d b y :