Welcome; Congratulations - Quadra-Fire 7100FP-GD-B Owner's Manual

1

Welcome

A. Congratulations
Congratulations on selecting a Quadra-Fire wood burning
fireplace. The Quadra-Fire fireplace you have selected is
designed to provide the utmost in safety, reliability, and
efficiency.
As the owner of a new fireplace, you'll want to read and
carefully follow all of the instructions contained in this
Owner's Manual. Pay special attention to all Cautions and
Warnings.
DEALER: Fill in
your name, address,
phone and email
information here and
fireplace information
below.
Fireplace Information:
Brand: ________________________________________________ Model Name: ___________________________
Serial Number: __________________________________________ Date Installed: __________________________
Listing Label Information/Location
Tested and
Listed by
UL 127-1996, ULC-S610-M87
LISTED FIREPLACE, SOLID FUEL TYPE, ALSO SUITABLE FOR MANUFACTURED
HOME INSTALLATION. (UM) 84 HUD. "For Use with Solid
Install and use only in accordance with manufacturer's installation, venting and operating instructions.
Any area incorporating warm or cold air ducts shall be enclosed in accordance with the manufacturer's
installation instructions.
Contact Your Local Building Or Fire Officials Or Authority Having Jurisdiction About Restrictions,
Installation Inspection And Permits Required In Your Area.
WARNING - For Manufactured Homes: Do not install in a sleeping room. An outside combustion air
inlet must be provided and unrestricted while unit is in use. The structural integrity of the manufactured
home floor, ceiling and walls must be maintained. The fireplace needs to be properly grounded to the
frame of the manufactured home.
Components required for installation: HTI SLSeries Pipe or Dura Plus System, Termination Cap, Hearth
Extension and required accessory Chimney Air Kit Part CAK4A.
Do not connect this unit to a chimney serving another appliance.
DANGER: Risk of electrical shock. Disconnect power supply before servicing.
Electrical Rating: 115 VAC <3.0 AMPS 60 Hz
Do not use grate or elevate fire. Build wood fire directly on firebrick.
Do not overfire. If heater or chimney connector glows, you are overfiring.
Do not use a fireplace insert or other products not specified for use with this product.
WARNING - THIS FIREPLACE HAS NOT BEEN TESTED WITH AN UNVENTED GAS LOG SET OR ANY LOG SET.
TO REDUCE RISK OF FIRE OR INJURY, DO NOT INSTALL AN UNVENTED GAS LOG SET OR ANY LOG SET
INTO FIREPLACE.
Must provide a source of air to prevent air starvation from combustion which could result of high levels
of carbon monoxide.
Replace glass only with 5mm ceramic available from your dealer.
Optional Fire Screen, Part SCR-433, may be used ONLY in USA
This wood heater needs periodic inspection and repair for proper operation. Consult owner's manual for further information. It is against federal regulations to operate this
wood heater in a manner inconsistent with the operating instructions in the owner's manual.
Mfg
by:
U.S. ENVIRONMENTAL PROTECTION AGENCY - Certified to comply with 2015 particulate emission standards. Not approved for sale after May 15, 2020.
This wood heater was found to have an average emissions rate of 3.1g/hr using method 5H.
Read this manual before installing or operating this fireplace.
Please retain this owner's manual for future references.
Local Dealer Information
Dealer Name: ________________________________________________________
Address: ____________________________________________________________
____________________________________________________________
Phone: _____________________________________________________________
Email: _____________________________________________________________
O-T L
Portland
Oregon USA
C US
OMNI-Test Laboratories, Inc.
Report: 061-S-41-2 A brand of Hearth & Home Technologies
7571 - 215th Street West, Lakeville, MN. 55044
www.quadrafire.com
TESTED TO:
Wood Fuel Only."
2015 2016 2017 2018 2019 2020
DO NOT REMOVE THIS LABEL
Quadra-Fire • 7100 FP Owner's Manual • 433-3600 • Rev J • 09/21/15
This Owner's Manual should be retained for future refer-
ence. We suggest that you keep it with your other impor-
tant documents and product manuals.
Your new Quadra-Fire wood burning fireplace will give you
years of durable use and trouble-free enjoyment. Wel-
come to the Quadra-Fire family of fireplace products!
Quadra-fire is a registered trademark of Hearth & Home
Technologies.
The model information regarding your specific fireplace can be found on
the rating plate usually located in the control area of the fireplace.
Model:
7100FP
E C F
PA ERTIFIED IREPLACE
Minimum Clearances To Combustible Material
Chimney sections at any level require a 2 inches
minimum air space clearance between the framing and
chimney section.
WITHIN ENCLOSURE AREA
Appliance to backwall
Appliance to sidewall
Duct boots to framing
Top standoffs to header
EXPOSED SURFACES
Faceplate to sidewall
Remote outlet air grills to ceiling
MANTEL
Mantel from base of fireplace
Maximum mantel depth
FLOOR PROTECTION
Combustible flooring 20 inches (508mm) in front of and 8 inches
(203mm) to either side of the fuel opening must be insulated with
non-combustible floor protection with a minimum thickness of 1
inch (25mm) and ("k" value = 0.43, minimum R value = 2.06).
In Canada: The hearth extension must be installed according to
the installation instructions.
Jan Feb Mar Apr May June July Aug Sept Oct. Nov. Dec.
Made in U.S.A. of US and imported parts
Serial No / Numéro De Série
009
(51mm)
Serial Number
1/2" (13mm)
1" (25mm)
0" (0mm)
Model Number
0" (0mm")
16" (406mm)
12" (305mm)
60" (1524mm)
12" (305mm)
433-1400
3