1. Manuals
  2. Brands
  3. Memorex Manuals
  4. CRT TV
  5. MT-1132
  6. Owner's manual

Memorex MT1132 Owner's Manual

13'' color television
Hide thumbs Also See for MT1132:
Table of Contents

Advertisement

Quick Links

See also: Service Manual
MT1132
13'' Color Television
Owner's Manual
As an
determined that this product meets the
guidelines for energy efficiency.
R
VIDEO INPUT
R
VOLUME
CHANNEL
VIDEO
AUDIO
®
E
S
NERGY
TAR
Partner, MEMCORP has
E
NERGY
POWER
®
S
TAR

Advertisement

Table of Contents
loading

Related Manuals for Memorex MT1132

Summary of Contents for Memorex MT1132

  • Page 1 MT1132 13'' Color Television Owner's Manual As an NERGY determined that this product meets the guidelines for energy efficiency. VIDEO INPUT POWER VOLUME CHANNEL VIDEO AUDIO ® Partner, MEMCORP has ® NERGY...
  • Page 2 BEFORE YOU OPERATE YOUR NEW TELEVISION To get the most from your new color television, read and follow this Owner's Manual carefully. INSTALLATION GUIDELINES Place your TV in a room with adequate ventilation. Keep your TV set away from sources of direct heat, such as heat registers or direct sunlight.

  • Page 3: Specifications

    FEATURES On-screen graphics guide you through setup features and operations Automatic programming of channels allows easy selection of stations available in your viewing area Sleep timer programs the TV to turn itself off at a preset time One day timer programs the TV to come on once at a preset time Weekly timer programs the TV to come on at a preset time every day 26-button infrared remote control allows remote operation VHF/UHF/CATV tuning allows reception of standard broadcasts or cable TV channels...
  • Page 4 LOCATION OF CONTROLS VIDEO INPUT POWER VOLUME CHANNEL VIDEO AUDIO POWER SWITCH CHANNEL (UP) BUTTON CHANNEL (DOWN) BUTTON VOLUME (UP) BUTTON VOLUME (DOWN) BUTTON REMOTE CONTROL SENSOR AUDIO IN (PUT) JACK VIDEO IN (PUT) JACK VHF / UHF EXT. ANT. JACK (REAR OF SET) EXT.ANT.

  • Page 5: Remote Control

    REMOTE CONTROL The REMOTE CONTROL unit requires two 1.5 volt "AA" size batteries. The BATTERY COMPARTMENT is located on the back of the unit. To open, press down of the lid and slide toward the bottom of the unit. Install the batteries exactly as shown by the diagram in the compartment.
  • Page 6 Number Buttons Press to select a channel. For channels 1-9, press 0, then the channel you want to watch. For example, for channel 6, press 0, 6. For channels 100-125, press the 100 button, then press the last two digits of the channel you want to watch.

  • Page 7: Antenna Connections

    ANTENNA CONNECTIONS If you are using an indoor or outdoor antenna (antennas no instructions below that correspond to your antenna system. television service (CATV), refer to CATV connections. Combination VHF/UHF Antenna (Single 75 ohm cable or 300 ohm twin-lead wire) 7 5 o h m T r a n s f o r m e r ( n o t i n c l u d e d )
  • Page 8 Some cable companies offer "premium pay" channels in which the signal is scrambled. Descrambling these signals for normal viewing requires the use of a descrambler device which is generally provided by the cable company. The illustrations below show how to connect these types of converter/descrambler devices with the TV's VHF antenna jack.
  • Page 9 input...

  • Page 10: Selecting A Language

    SELECTING A LANGUAGE The menu screen that appears when you press the MENU button can be programmed to appear in English, French, or Spanish. Follow the directions below to program the menu screen to appear in a language other than the one that is now on-screen when you press the MENU button.

  • Page 11: Setting The Clock

    SETTING THE CLOCK Press the MENU button twice to bring up the menu screen and select CLOCK SET. CLOCK SET SUN - - : - - AM EXIT [MENU] MOVE [+] / [-] ADJUST Use the + or – button to select the correct day of the week.
  • Page 12 PROGRAMMING CHANNELS With automatic programming, the TV automatically places every channel you receive in its memory, allowing you to scan through those channels when you press the CHANNEL (Up/Down) buttons. With manual programming, you tell the TV what channels you want to scan through when you press the CHANNEL (Up/Down) buttons.

  • Page 13: Manual Programming

    ADDING/DELETING CHANNELS Manual Programming Press the MENU button to bring up the menu screen. MENU TUE 1 : 35PM CLOCK SET PROGRAM TIMER V-BLOCK SET PICTURE ADJUST CH PROGRAM LANGUAGE EXIT [+] / [-] : MENU SELECT [MENU] : ENTER Use the + or –...

  • Page 14: Setting The Timers

    SETTING THE TIMERS You can program your TV to turn on a specific channel at a preset time once (one day timer) or at the same time every day or every week (weekly timer). You also can program your TV to turn itself off after a specified amount of time (Sleep timer). One Day Timer Press the MENU button to bring up the menu-screen.
  • Page 15 Weekly Timer Press the MENU button to bring up the menu screen. MENU TUE 1 : 35PM CLOCK SET PROGRAM TIMER V-BLOCK SET PICTURE ADJUST CH PROGRAM LANGUAGE EXIT [+] / [-] : MENU SELECT [MENU] : ENTER Use the + or – button to highlight PROGRAM TIMER, then press the MENU button.
  • Page 16 Sleep Timer Press the SLEEP button to bring up the sleep timer screen. SLEEP 00 To check the time remaining for a sleep timer, press the SLEEP button. The time remaining will appear on-screen. To cancel a sleep timer, follow step 1 to bring up the sleep timer screen. Then press the SLEEP button until 00 appears on-screen.

  • Page 17: Adjusting The Picture

    ADJUSTING THE PICTURE Press the MENU button to bring up the menu screen. MENU TUE 1 : 35PM CLOCK SET PROGRAM TIMER V-BLOCK SET PICTURE ADJUST CH PROGRAM LANGUAGE EXIT [+] / [-] : MENU SELECT [MENU] : ENTER Use the + or – button to highlight PICTURE ADJUST, then...
  • Page 18 CLOSED CAPTION MODE Close caption mode allows you to read the words of a broadcast on-screen while you are hearing them. There are two types of closed captioning: Captions – Dialogue and descriptions of the action appear in a box at the bottom of the screen.
  • Page 19 CABLE TV OPERATION Press the MENU button to bring up the main menu screen. Use the + or – button to highlight CH PROGRAM, then press the MENU button to select it. Press the MENU button until CABLE appears to the right of AIR/CABLE. On CATV (Cable Television) systems, programs are brought into the home on VHF channels 2–13, mid-band channels A–I, super band channels J–W, hyper band channels AA–CCC, ultra band channels W+30–W+84 and sub midband channels (5A, A5–A1).
  • Page 20 SETTING V-BLOCK V-Block allow users to program their TV set to automatically block an incoming program that contains a particular level of violence, sexual content and strong language . User can easily block program based on the age based ratings, the content based ratings, or a combination of the two.
  • Page 21 SETTING MPAA RATING (CHANGE RATING-1) Go to menu display item no. 6 of SETTING V-BLOCK. V-BLOCK SET V-BLOCK CHANGE RATING CHANGE NUMBER 0000 EXIT [+] / [-] : SELECT [MENU] : ENTER Press the MENU button. V-BLOCK SET MPAA RATING PG-13 TV RATING TV-PG-DLSV OPTION RATINGOFF...
  • Page 22 SETTING TV RATING-1 (CHANGE RATING-2) Go to menu display item no. 2 of SETTING MPAA RATING. V-BLOCK SET MPAA RATING PG-13 TV RATING TV-PG-DLSV OPTION RATING OFF LOADING EXIT [+] / [-] : SELECT [MENU] : ENTER Use the + or - button to highlight TV RATING V-BLOCK SET MPAA RATING...
  • Page 23 Table 1 indicates the only valid combinations of age and content based ratings with an "X" in the appropriate boxes. For example, TV-14-S,V is a valid rating, as is TV- 14. However, TV-14-FV is not a valid rating. Age-based Rating TV-Y TV-Y7 TV-G...
  • Page 24 For example : If user chooses to block any program with TV-PG-V rating, all entries in that column are automatically blocked as shown in table 2. At the same time it will cause no blocking of any program with D, L, S rating. Similarly, the same will happen if user chooses to block other rating such as D, L or S.
  • Page 25 CHANGING A PASS NUMBER Go to menu display item no. 4 of SETTING V-BLOCK. V-BLOCK SET V-BLOCK CHANGE RATING CHANGE NUMBER 0000 EXIT [+] / [-] : SELECT [MENU] : ENTER Use the + or - button to highlight CHANGE NUMBER. V-BLOCK SET V-BLOCK CHANGE RATING...
  • Page 26 SETTING OPTION RATING (CHANGE RATING-3) This setting is use to receive data service for Canadian English Language Rating System in accordance with EIA-744-A Standard. Go to menu display item no. 2 of SETTING MPAA RATING. V-BLOCK SET MPAA RATING PG-13 TV RATING TV-PG-DLSV OPTION RATING OFF...
  • Page 27 SETTING LOADING Go to menu display item no. 8 of SETTING OPTION RATING. V-BLOCK SET MPAA RATING PG-13 TV RATING TV-PG-DLSV OPTION RATING ON LOADING EXIT [+] / [-] : SELECT [MENU] : ENTER Press the MENU button. The OFF (or ON) to the right of LOADING will flash.
  • Page 28 BEFORE REQUESTING SERVICE BEFORE REQUESTING SERVICE Before requesting service, check the following list of problems and solutions. You may be able to solve the problem yourself. PROBLEM No Power Make sure the unit is plugged in. Unplug the unit from the electrical outlet for 60 seconds. Then plug it in and turn it on again.

Table of Contents