Table of Contents
Advertisement
for fit No. 342473
DEVICE PACKED WITH
RANGE
SEE INSTRUCTIONS
Phillips head screwdriver
Device attaches to floor or wall to
hold either right or left rear leg
leveler. If fastening to floor, be sure
that screws do not penetrate
electrical wiring or plumbing. If
this cannot be determined, use
shorter screws that will not
penetrate through flooring.
If the device came with your range,
it is shipped attached to the lower
range back. Remove and discard
the shipping screw that holds the
device and then follow instructions
below.
1. Decide whether the device will
be installed on the right or left side
of range location.
30
Fig. 1
Attachment to
wall
Screw must enter wood or metal _
Fig. 2
2.
If the device side of the range is
adjacent to a cabinet, place the
device against back wall and
cabinet as shown in figure 1.
If there is no adjacent cabinet,
determine where the location of the
range side (painted outside panel)
will be. Place the device with its
outside edge at this location and
against back wall. See figure 1.
Determine whether you will
3.
anchor the device to the floor or to
the wall as shown in figure 2.
Fasten the device securely with the
screws provided. Screws are self-
drilling in wood, plywood, particle
and chi~ board. and most metal
Outside edge of bracket to be
flush with left or right side
Device
Wall plate
,
masonry you can buy suitable
screws and anchors at hardware
stores. Use a masonry drill to drill
the required holes.
4.
Using the wrench, back out the
four leg levelers at least two turns.
See your installation guide for
more leveling information before
positioning range.
Slide the range into place. Be
5.
sure rear leg leveler fully engages
slot in device. If range cannot be
moved back far enough for rear leg
leveler to enter device, move device
forward as required and attach to
floor in new location.
Advertisement
Table of Contents
