Table of Contents
Advertisement
UNIVERGE SV8100
Park
Park places a call in a wait state (called a Park Orbit) so that an extension user may
pick it up. There are two types of Park: System and Personal. System Park allows a
user to have a call wait in System Orbit.
Personal Park allows a user to Park a call at their extension so a co-worker can pick it
up. After parking a call in orbit, a user can Page the person receiving the call and
hang up. The paged party can dial a code or press a programmed Park key to pick up
the call. With Park, it is not necessary to locate a person to handle their calls. A call
parked for too long recalls the extension that initially parked it, however the call
remains in the park orbit until it is answered. There are 64 Park Orbits (1~64)
available for use.
Extended Park
An extension Class of Service determines whether it uses the normal Park Orbit
Recall time or the Extended Park Orbit Recall time. The times are set in system
programming. When an extension with Extended Park Recall Class of Service option
parks a call, it recalls after the Extended Park Orbit Recall time. When an extension
with the Normal Park Orbit Recall Class of Service option parks a call, it recalls after
the normal Park Orbit Recall time, however the call remains in the park orbit until it is
answered.
Programmable Function Key and Service Code Available for Personal Park
The Personal Park feature is enhanced by using a Programmable Function Key or
service code (3-digit or 1-digit) to place a call in Personal Park. This option is
available for multiline terminals, single line sets, and UNIVERGE SV8100 Wireless
telephones and can be used for analog or ISDN trunks.
PBX Compatibility
You can connect your telephone system trunks to Centrex/PBX lines, rather than to
Telco trunk circuits. This makes the trunk inputs into the system 500/2500 type
compatible Centrex/PBX extensions, rather than Telco circuits. PBX Compatibility
lets the system be a node (i.e., satellite) in a larger private telephone network. To
place outside calls when the system is behind a PBX, telephone system users must
first dial the PBX trunk access code (usually 9).
The system provides the following PBX Compatibility options:
General Description Manual
PBX Trunk Access Code Screening
The system can monitor the numbers users dial and screen for PBX trunk
access codes. The system can screen for up to four groups of trunk access
codes. The codes can have one or two digits, consisting of the digits 0~9,
. (You can use Line Key 1 as a wild card entry.)
Issue 3.0
and
#
2 - 45
Advertisement
Table of Contents
