Freezer Drawer And Slides Removal And Replacement - GE GBS22**P Technical Service Manual

Removal and Replacement
1. Open the freezer drawer until it stops.
2. The bottom basket rests on a frame inside the
lreezer drawer. To remove it, liftthe basket
ftom the back and slide it toward the freezer
compartment.
3. Remove the single Phillips-head screw on
each side of the rail.
Note: Do not remove the hex-head screws from
the rail assemblies.
The tabs on the side of the drawer rails fit into
the front slots of the guide rails. Lift the drawer
by the handle to separate the drawer rails ftom
the guide rails.
Set the drawer on a non-scratching surface.
Remove the middle basket, top basket, ice tray
shelf, dnd ice bin.
The center rail assembly is held in place by a
molded channel in the treezer ceiling and
notches in the metal support rails. Remove the
center rail assembly by pressing down on the
metal support rails while rotating the bottom
edge of the center rail assembly.
To remove the metal support rails, press the
tabs on the plastic support housing.
Remove the 3 Phillips screws that hold the
plastic support housing in place.
5.
6.
7.
8.
4.
o
IXt t{OTnmow ter headccnua