Initial Settings; Adjusting Initial Settings; Switching Auto Pi Seek; Switching The Warning Tone - Pioneer KEH-P6021R Operation Manual

CRD3539A_Eng 9/21/01 4:44 PM
Section

Initial Settings

08

Adjusting initial settings

Initial settings lets you perform initial set up of
different settings for this unit.
1
display
FUNCTION
Shows the function status.
1 Press and hold until the unit turns
SOURCE
off.
2 Press
FUNCTION
appears in the display.
3 Press
FUNCTION
settings.
Press repeatedly to switch between
FUNCTION
the following settings:
— —
A-PI WARN AUX
FRT+REAR
Use the following instructions to operate each
particular setting.
• To cancel initial settings, press
• You can also cancel initial settings by holding
down until the unit turns off.
FUNCTION
34
En
<CRD3539-A>34
Page 34
1
and hold until
A-PI
to select one of the initial
— — —
DIMMER ILL.CLR
.
BAND/ESC

Switching auto PI seek

The unit can automatically search for a different
station with the same programming, even dur-
ing preset recall.
1 Press to select
FUNCTION
Press repeatedly until
FUNCTION
in the display.
on or off with 5/∞.
2 Select
A-PI
Pressing 5/∞ will switch
off and that status will be displayed (e.g.,
).
A-PI :ON

Switching the warning tone

If the front panel is not detached from the head
unit within five seconds of turning off the igni-
tion, a warning tone will sound. You can turn off
this warning tone.
1 Press to select
FUNCTION
Press repeatedly until
FUNCTION
appears in the display.
on or off with 5/∞.
2 Select
WARN
Pressing 5/∞ will switch
and off and that status will be displayed (e.g.,
).
WARN :ON
.
A-PI
appears
A-PI
between on and
A-PI
.
WARN
WARN
between on
WARN