LG LRE30451S Installation Manual page 6

Part 3 ELECTRICAL CONNECTIONS
Follow the instructions under "Install the power cord as
follows" on page 5 to correctly install the strain relief.
1. Remove the lower 3 screws from the terminal block
and retain them. (Refer to Figure 7.)
Remove the ground screw and retain it.
2. Remove ground strap and discard as shown
in Figure 7.
Do not discard any screws.
3. Insert the ground screw into the power cord ground
wire terminal ring and secure it to the range frame.
4. Insert the 3 screws through each power cord
terminal ring and into the lower terminals of the
terminal block. Make sure that the center wire
(white/neutral) is connected to the center lower
position of the terminal block.
Tighten 3 screws securely into the terminal block.
5. Go to page 8.
3-wire connection: conduit
Install the conduit as follows:
Remove the Conduit connection plate from the rear of
drawer body and rotate it as shown in Figure 8. The
conduit hole (1 1 / ") must be used.
8
First, prepare conduit wires as shown in Figure 9.
3 wire
FIGURE 9
Second, install conduit as shown in Figure 10.
For conduit installations, after purchasing a strain
relief, insert it in the conduit hole (1
the conduit through the body of strain relief and
fasten the strain relief with its ring. Reinstall the
bracket.
For conduit connections :
If the wire in the conduit is copper it must be 8 or 10
AWG wiring.
If the wire in the conduit is aluminum it must be 6 or 8
AWG wiring.
4 wire
or
1 / "). Then install
8
4-wire connection
Remove the Conduit connection plate
Conduit connection plate
6
FIGURE 7
FIGURE 8
Assemble the
strain relief hole
Reinstall the
FIGURE 10