LG LRE30451S Installation Manual page 5

Part 3 ELECTRICAL CONNECTIONS
3-wire connection with a power supply cord
WARNING
The middle (neutral or ground) wire of the power cord or
3-wire conduit has to be connected to the middle post of
the main terminal block. The remaining two wires of the
power cord or conduit have to be connected to the
outside posts of the main terminal connection block.
Install the power cord as follows:
For power cord installations, Hook the strain relief
over the power cord hole (1
of drawer body. Insert the power cord through the
strain relief and tighten it. (Refer to Figure 5.)
You must install the power cord with a strain relief.
1. Remove the lower 3 screws from the terminal block
and retain them. (Refer to Figure 6.)
2. Insert the 3 screws through each power cord
terminal ring and into the lower terminals of the
terminal block.
Make sure that the center wire (white/neutral) is
connected to the center lower position of the
terminal block.
3. Tighten 3 screws securely into the terminal block.
Do not remove the ground strap connections.
4. Go to page 8.
4-wire connection with a power supply cord
WARNING
Only a 4-conductor power-supply cord kit rated
120/240 volts, 50 amperes and marked for use with
ranges with closed-loop connectors, open-end spade
lugs with upturned ends shall be used. The middle
(neutral) wire of the power cord or 4-wire conduit has
to be connected to the middle post of the main terminal
block. Other two wires of the power cord or conduit
have to be connected to the outside posts of the main
terminal connection block. The 4th ground wire must
be connected to the frame of the range with the ground
screw.
3 / ") located below the rear
8
Separate Strain Relief
before installation
Assemble the strain relief
to the 1 3 / " opening in
8
Conduit connection plate
3-wire connection
5
FIGURE 5
FIGURE 6