A.stby; Enjoying Sound At Low Volume; Auto Standby Function - Sony HT-CT260 Operating Instructions Manual

HT-CT260/HT-CT260HP - HTCT260_CT260HP__EN_FR_ES.pdf
Note
• To receive a Dolby Digital signal, you need
to connect a digital satellite tuner to the
Sound Bar with an optical cable or coaxial
cable, and set the digital output mode of the
digital satellite tuner to Dolby Digital.
• M/S: Main sound is output
from the left speaker and
sub sound is output from
the right speaker.
• MAIN: Plays back only the main
channel.
• SUB: Plays back only the sub
channel.
Enjoying the sound at
low volume (NIGHT)
You can enjoy sound effects and hear the
dialog clearly even at a low volume level
using this function.
• ON: Turns on the "NIGHT"
function.
• OFF: Turns off the function.
Tip
• You can listen to Dolby Digital sound at low
volume by using DRC (page 34).
Setting and releasing
B l u e t o o t h standby
mode (BT STBY)
If Bluetooth standby mode is set to ON,
the Sound Bar is in Bluetooth standby
mode even when it is turned off. When
the Bluetooth device attempts to make
connection, the Sound Bar is turned on,
and you can enjoy sound with Bluetooth
connection.
• ON: Bluetooth standby mode is
enabled.
35 of 130
• OFF: Bluetooth standby mode is
disabled.
Notes
• If the Sound Bar does not have the pairing
registration information, Bluetooth standby
mode cannot be set.
• During Bluetooth standby mode, standby
power consumption increases.

Auto Standby function

(A. STBY)
You can reduce power consumption.
The Sound Bar enters standby mode
automatically when you do not operate
the Sound Bar for about 30 minutes and
the Sound Bar is not receiving an input
signal.
• ON: Turns on the "A. STBY"
function.
• OFF: Turns off the function.
Relaying the command
from the remote control
of a TV (IR REP.)
If the remote control of a TV cannot
control the TV, the Sound Bar can relay
the remote control signal to the TV to
control the TV. The remote control
signal can be relayed even when the
Sound Bar is turned off.
• ON: The relay function is enabled.
• OFF: The relay function is disabled.
Notes
• Be sure to check that the remote control of
the TV cannot control the TV, then set IR
REP. to ON. If it is set to ON when the
remote control can control the TV,
appropriate operation may not be obtained,
because of the interference between the
continued
35
US
http://www.docs.sony.com/release/HTCT260_CT260HP__EN_FR_...
3/24/13 8:44 PM