Agri-Fab 45-02113 Owner's Manual page 6

For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
17. Place a 5/16" flat washer onto the end of the flow control
rod. Insert the end of the rod through the slot in the flow
control mounting bracket and through the hole in the
flow control link. Secure with a 3/32" x 3/4" cotter pin.
See figure 8.
5/16" FLAT
WASHER
FLOW
CONTROL
ROD
FIGURE 8
18. Hook the free end of the flow control rod through the
hole in the slide gate bracket located near the bottom
of the hopper. See figure 9.
FIGURE 9
19. Assemble the flow control mounting bracket to the hitch
3/32"
COTTER
PIN
SLOT
FLOW
CONTROL
LINK
FIGURE 10
20. Place the adjustable stop into the "ON" end of the slot
FIGURE 11
6
www.mymowerparts.com
tube using two 1/4" x 1-3/4" hex bolts, six 5/16" flat
washers and two 1/4" hex lock nuts as shown in figure
10. Do not tighten at this time.
FLOW CONTROL
MOUNTING BRACKET
1/4" x 1-3/4"
HEX BOLT
5/16" FLAT
WASHER
5/16" FLAT
WASHER
in the top of the flow control mounting bracket. Secure
with the 1/4" x 3/4" carriage bolt, a nylon washer, a 5/16"
flat washer and the nylon wing nut. See figure 11.
NYLON
WING NUT
5/16" FLAT
WASHER
NYLON
WASHER
1/4" x 3/4"
CARRIAGE BOLT
1/4" HEX
LOCK NUT
ADJUSTABLE
STOP