Agri-Fab 45-02113 Owner's Manual page 5

For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
9. Assemble a spacer and a 1-5/8" flat washer onto the
end of the axle that has the large hole. See figure 4.
10. Place a wheel (air valve facing out) onto the axle.
Secure the wheel to the axle with a 1/4" x 1-3/4" hex bolt
and a 1/4" hex lock nut. See figure 4.
1/4" x 1-3/4"
HEX BOLT
AIR VALVE
1/4" HEX
LOCK NUT
FIGURE 4
11. Turn the spreader upright on its wheels.
12. Assemble the hitch bracket to the top of the hitch tube
using two 3/8" x 1-1/4" hex bolts, 3/8" lock washers and
3/8" hex lock nuts. See figure 5.
13. Assemble the hitch pin through the hitch bracket and
the hitch tube and secure with the hair cotter pin. See
figure 5.
HITCH PIN
FIGURE 5
1-5/8" DIA.
FLAT WASHER
SPACER
3/8" x 1-1/4"
HEX BOLT
3/8" LOCK
WASHER
3/8" HEX
LOCK NUT
HAIR COTTER PIN
www.mymowerparts.com
14. Assemble the flow control link (end with small hole) to
the flow control arm using a 1/4" x 3/4" hex bolt, a nylon
washer and a 1/4" hex lock nut. Tighten carefully. The
flow control link should not be loose but should pivot
with no more than slight resistance. See figure 6.
FLOW CONTROL
LINK
1/4" x 3/4"
HEX BOLT
SMALLEST
HOLE
NYLON
WASHER
FIGURE 6
15. Assemble the flow control arm to the flow control
mounting bracket using a 1/4" x 3/4" hex bolt, two nylon
washers and a 1/4" hex lock nut as shown in figure 7.
Tighten carefully. The flow control arm should pivot
with a slight resistance.
16. Assemble the vinyl grip. See figure 7.
VINYL GRIP
FLOW
CONTROL
ARM
1/4" x 3/4"
HEX BOLT
(2) NYLON
WASHERS
FIGURE 7
5
FLOW
CONTROL
ARM
1/4" HEX
LOCK NUT
FLOW CONTROL
MOUNTING
BRACKET
1/4" HEX
LOCK NUT