Advertisement
How to Set the
Door Alarm
You don't have to set the visual
alarm.
As long as either door is
open, the red DOOR OPEN signal
light flashes.
If the green signal light on the
DOOR ALARM pad is glowing,
the beeper alarm is set.
If it's not,
touch the pad to turn it on.
If either door is open for more than
30 seconds, a recurring beep sounds.
The light goes out and the beeping
stops when you close the door.
There are times when you'll want
the Door Alarm beeper turned
off.
When you're rearranging a lot
of food, for example. Just touch the
pad. The green light will go out
and the beeping will stop.
Why the Red Warm
Temperature Light Glows.
At first, it's probably because your
newly installed refrigerator hasn't
completely cooled down yet. Wait
a few hours for it to cool, and then
the light will go out.
From then on, the red light will
glow whenever temperatures inside
get too high for proper food storage.
If this happens, open the doors
only when absolutely necessary,
and close them as quickly as
possible.
As soon as inside temperatures
return to normal, the light goes out.
How the Electronic
Monitor and Diagnostic
System Works.
The word NORMAL is lighted
in green except when a failure has
been detected.
The SYSTEM CHECK-RESET
pad has two functions:
1. You can touch the SYSTEM
CHECK-RESET
pad and get a
review of the electronic diagnostic
codes in order of their priority.
2. You can touch the SYSTEM
CHECK-RESET
pad to erase three
flashing codes immediately and
two codes after the condition that
caused them to flash has been
corrected (see page 8).
Deactivating the Door Alarm
beeper does not turn the red DOOR
OPEN light off—it keeps flashing
until the door is closed.
(continued next page)
Part No. 488347P02
Advertisement
