Advertisement
!POSSBLE
CYW$E
AND FHVEDY
WATER
D!
SPENSER
@ W4tersupnlyline turnedior
not connected.
I
DcEs
NCN'WORK '
' "
I
DWIDER EETWEEN
FRESHFOODAND
fWEEZEF? C OMPAFW
MENTSFEELSWARM
MOISTURE F6RMS
ON CWTSIPE OF
REWK3ERATOR
REH%KM3A?'OR
HASODOR
MOIST-(JFE
COLLECTS iiWYDE
I
WATERON FLOOR
TO REPLACEA LIGHT
BULB IN FRESH FOO[
COfviPARTMEhlT:
—
TO FWWLACE A LIGHT
BULB IN FREEZER
coMi-?4Fmv?Hvr
OF
MC) DEL C.SF22:
TO REPLACE A LIGHT
BULB IAI FREEZER
tXlbfPARTMEP++iT O F
]MODELCSF24:
I
* SupplyMMmaybe cloggjedwithsediment.
* ~~rmai warmth is ~reated byautam~ti~ energy saver system Mculfitlfifj warm
liquid around front edge of freezer compartment to help @%wm% condensation cm
''
outsideof refrigeratorin
hot, humid weatheri
.——
QI
I Vot
unusual d uring periadof high humidity.
* Foods with strong odors should be tightly covered.
@ Check for spoiled food.
* Interior needs cleaning. Refer to page 9,
@Defrost water pan needs cleaning,
~
Keep
open
box
of
baking
soda
in
refrigerator;
replac,emonthly,
@ Too frequent and too long door openings.
@In humid weather air carries moisture into rd'rigeratorwhen doors are opened,
—
——
~ Defrost water pan full, missing or not in position.
1. Unplug refrigerator.
2. Turn numbered tempwature control to OFF and pull off knob.
3. Pull bottom of light panel down
about X" —just enough to disengage
lip at rear from grooves in
retainers on rear wall.
4. Lift panel to disengage top from
pins on side walls, and remove panel.
After repiacing with same size bulb,
reinstall panel (hang top on pins; pull
bottom down, push it back and release
it to let lip engage grooves in retainers). Replace temperature control knob in OF-F
position, turn it to previous setting, and plug refrigerator back in.
1. Unplug refrigerator
2. Lift light panel to disengage bottom from pins on
m
side walk and top from the channel it mates with.
w
~
Remove iight panel.
----
, ----
After replacing with same size bulb, reinstall panel
(lower top into channel, and bottom over pins).
3. Plug in refrigerator.
f. Unplug refrigerator.
2. Remove the shelf that's just below light shield.
(Shelf will be easier to remove if it is emptied first.)
3. Pull piastic light shieid toward you, (it wiii bcmd
to free tabs from grooves. )
4. Fk3piaceimdbwiti~ same size buib.
5. l%?instaiishieid and sheif.
6, piug in refrigerator.
Advertisement
