Table of Contents
Advertisement
Energy Saver Fan
Cycle Switch
ENERGY
NORMAL
SAVE
This switch conwols the fan
operation.
NORMAL setting allows continuous
fan function, circulating air even
when the compressor has cycled off
and the thermostat setting has been
reached. This setting is recommended
for maximum comfort.
SAVE setting lets the fan cycle on
and off with the compressor during
cooling. The fan stops when the
thermostat setting is satisfied. This
setting results in longer off time
and wider variations of room
temperature and humidity. This
setting is normally used when the
room is unoccupied.
CLOSE
VENT
OPEN
(ON THE GRILLE FRAME
ABOVE THE CONTROL PANEL)
Ventilation Control
When you move the Ventilation
Control to CLOSE, the vent door is
closed and only the air inside the
room will be circulated and
conditioned. Moving the control to
OPEN opens the vent door,
allowing a small amount of indoor
air to be exhausted from the room.
However, cooling effectiveness is
reduced when this control is set at
keep it there long+ specially in
hot, humid weather.
For normal cooling
1. Set the Selector Switch at HIGH
COOL.
2. Set the Thermostat Control at
the desired number (usually 5-7 is a
good starting position). If room
temperature is not satisfactory after
a reasonable time, set the
Thermostat Control at a higher
number for a cooler room or at a
lower number for a warmer room.
3. Set the Energy Saver Switch at
NORMAL position for continuous
fan operation or at SAVE position
to automatically cycle the fan on
and off with the compressor.
4. Set the Ventilation Control at
CLOSE except for brief periods
when you want to exhaust room air
to the outside.
For maximum cooling
1.
Set the Selector Switch at
HIGH COOL.
2. Turn the Thermostat Control
to 10.
3. Set the Ventilation Control at
CLOSE.
4. Set the Energy Saver Switch at
the NORMAL position.
I
For quieter operation
1. Set the Selector Switch at LOW
COOL position.
2. Slide the Thermostat Control to
the desired number.
3. Set the Ventilation Control at
CLOSE.
4. Set the Energy Saver Switch at
NORMAL position.
Note: When the Energy Saver
Switch is at the SAVE position,
changes in the sound level may be
more noticeable than when it's at
For nighttime operation
During the cooler evening hours, w
recommend that you set the Selecto
Switch at LOW COOL for quieter
operation and the Thermostat
Control at mid-range (5 or 6). Set
the Ventilation Control at CLOSE
and the Energy Saver Switch at
NORMAL or SAVE position.
For extreme temperatures
For greatest economy and best
performance, we suggest that you
set the Selector Switch at HIGH
COOL in extremely hot weather.
To adjust air direction
Up and down
The up-and-down air direction
louvers are controlled by a tab tha
lets you position the louvers to
discharge the air up, down or
straight out.
Side to side
CIRCULAIRE
OFF
For fixed side-to-side air
direction, set the Circulaire Switcl
to ON until the desired air directiol
is obtained, then move it to OFF.
For continuous side-to-side air
circulation, set the Circulaire
Switch to ON and leave it there.
ON
Advertisement
Table of Contents
