Transfer Mode; Vfo Functions; Personal Computer Interface - Kenwood TK-80 Service Manual

TK-80
Menu
32 Squelch opening time (unmute time) setting
33 Memory code A setting (call ID)
34 Memory code B setting (call ID)
35 Memory code C setting (call ID)
36 Memory code D setting (call ID)
37 Memory code A setting (character)
38 Memory code B setting (character)
39 Memory code C setting (character)
40 Memory code D setting (character)
41 User manu memory code setting ON/OFF
42 ID delay time setting

6. Transfer Mode

This mode is used to copy the memory and menu data
from one TK-80 unit to one or more others to create
"TRANS".
6-1. Procedure
1) Connect a cross cable (E30-3232-05) to the ACC1 connec-
tors on two TK-80 units, as shown in the figure.
2) Turn on the power of the unit receiving the data.
3) Enable the Dealer mode in the unit to be transferred, then
press [DATA].
As the unit enters the Dealer mode, it automatically de-
tects the connected second TK-80 unit, displays "TRANS"
and begins the transferring transmission.
4) When transferring ends normally, the first TK-80 returns
to the Dealer mode which is then shown on its display.
Note:
• Transfer is not possible when the destination diode (D8,
D9, D10, D15) setting of the two units differ.
• Transfer is not possible when neither of the two units is
equipped with transmit power setting diode (D7).
6
REALIGNMENT
Content

7. VFO Functions

Dip SW3 is set to ON when shipped from the factory.
Should the VFO mode fail to function, please check to see
that Dip SW3 is set to ON.
7-1. Procedure
1) Press [MENU] to enable the user Menu mode.
2) Press [DATA] or [MODE] to select No. 00.
3) Use [DIAL] to switch the memory to VFO.
4) Press [MENU] to select VFO.
7-2. Description
1) [DIAL] changes from selecting memory channels to se-
lecting VFO frequencies.
2) [SCAN] changes to selecting the step frequency and the
F. LOCK function.
Pressing [SCAN] scrolls through the settings in the follow-
ing order:
10Hz → F. LOCK → 100kHz → 1kHz → 10Hz
Turning the [DIAL] after changing the step frequency
rounds the lower digit off to "0".
3) When in the user Menu mode, memory channel frequen-
cies and type of emissions (MODE) are set in the VFO at
the point control is switched from Memory to VFO.
4) [DIAL] and [MENU] are disabled during F. LOCK.
5) Even if AT tuning is established during VFO, the changing
of the frequency automatically credits the state of AT
through.

8. Personal Computer Interface

In addition to commands (in the instruction manual) made
available to users, the SR (system reset) command is made
available only to dealers.
Note:
• SRP1 = Reset the user menu
SRP2 = Reset all
• The reset user Menu command resets all menu settings
to the factory defaults.