Dealer Menu Mode; Alphanumeric Display Data Write Mode (Blank); Contents - Kenwood TK-80 Service Manual

■ Alphanumeric display data write mode (Blank)

This mode is used to write alphanumeric display data (up
to 7 digits) to the memory channels.
1) Turning the [DIAL] triggers a display that scrolls continu-
ously in the following order:
Blank A B ...
9 ...
Blank H P
A I Q
B J R
C K S
D L T
E M U
F N V
G O W
2) Digits are set starting from the left side. Pressing [SCAN]
moves the cursor one digit position to the right.
3) Pressing [DATA] changes control to the:
• Transmit power limit write mode (when specified diode
D7 is installed)
• Memory channel selector mode (when specified diode D7
is not installed)
■ Transmit power limit write mode (100W)
This mode is used to write the transmit power limit to the
memory channel.
1) Turning the [DIAL] triggers a display that scrolls continu-
ously in the following order:
MAXIMUM (100W)
LOW (15W)
2) Press [DATA] to enable the memory channel switching
mode.
REALIGNMENT
Z 14 types of symbols
1 0
X , * 7
Y - 0 8
Z / 1 9
$ = 2
1/1 @ 3
< \ 4
> _ 5
+ # 6
HIGH (50W)
MEDIUM (25W)

5. Dealer Menu Mode

This mode is used to select functions the dealer sets for
the user.
5-1. Selecting the dealer menu mode
Press [MENU] while in the dealer mode's memory chan-
nel selector mode or any of its write modes.
5-2. Menu number selection
To select menu numbers, press the [DATA] or [MODE]
keys.
5-3. Selecting the setting contents
To change menu settings, turn the [DIAL].
Note:
• Menu numbers are designed to scroll in order continu-
ously.
• Menu items are designed to scroll in order continuously.
• If the menu is scrolling, turn the [DIAL] to display the item,
then select the desired setting.
• The selective call ON/OFF status and any memory code
setting changes from the User menu mode will be re-
flected in the Dealer menu's settings.
Menu
00 VFO transmit power and receive-only setting
01 MIC gain H/L setting
02 CW/selective call IF filter attachment
03 DATA (AFSK) IF filter attachment
04 AIP ON/OFF
05 AUX ON/OFF
06 Scan speed setting
07 BC AM 1/9kHz steps
08 Clarifier 10/1Hz steps
09 VOX ON/OFF
10 CW delay time setting (full/semi break-in setting)
11 CW sidetone/pitch frequency setting
12 Power setting (H, M, L) display ON/OFF
13 Channel number display ON/OFF
14 DATA mode AFSK/FSK setting
15 DATA (FSK) IF filter selection
16 FSK shift width setting
17 FSK key polarity setting
18 FSK H/L tone setting
19 FSK reverse setting
20 SCAN SW actuation enable/disable
21 MENU SW actuation enable/disable
22 MODE SW actuation enable/disable
23 DATA SW actuation enable/disable
30 Selective call ON/OFF
31 ID (own unit) code setting
TK-80
Content
5