Table of Contents
Advertisement
2-6:
TRAVERSE HOLDER/INSULATOR (F)/INSULATOR
(R) (Refer to Fig. 2-6-A)
1.
Remove the Traverse Holder.
2.
Remove the 2 Insulator (F).
3.
Remove the Insulator (R).
Main Chassis Ass'y
Insulator (F)
Traverse Holder
NOTE
1.
In case of the Insulator (F) installation, install correctly as
Fig. 2-6-B.
2.
In case of the Insulator (R) installation, install correctly as
Fig. 2-6-C.
Insulator (F)
Insulator (R)
2-7:
RACK FEED ASS'Y/SWITCH PCB ASS'Y/FEED
MOTOR (Refer to Fig. 2-7-A)
Remove the screw 1.
1.
2.
Remove the Rack Feed Ass'y.
Remove the screw 2.
3.
4.
Remove the Switch PCB Ass'y.
Remove the 2 screw 3.
5.
6.
Remove the Feed Motor.
7.
Remove the Motor Gear.
2
Switch PCB Ass'y
Main Chassis Ass'y
• Screw Torque: 5.0 ± 0.3kgf•cm (Screw 1)
• Screw Torque: 3.0 ± 0.3kgf•cm (Screw 2)
• Screw Torque: 1.0 ± 0.3kgf•cm (Screw 3)
DISASSEMBLY INSTRUCTIONS
Insulator (R)
Insulator (F)
Fig. 2-6-A
Traverse Holder
Fig. 2-6-B
Main Chassis Ass'y (Top Side)
Fig. 2-6-C
1
Rack Feed Ass'y
3
3
Motor Gear
Feed Motor
Fig. 2-7-A
NOTE
1.
When pushing the Rack Feed in the direction of the
arrow, it should be restored to the original position by the
spring force. (Refer to Fig. 2-7-B)
2.
In case of the Motor Gear installation, check if the value
of the Fig. 2-7-C is correct.
3.
When installing the wire of the Switch PCB Ass'y, install it
correctly as Fig. 2-7-D.
4.
After the assembly of the Main Chassis Ass'y, hook the
wire on the Main Chassis Ass'y as shown Fig. 2-7-E.
Push
Motor Gear
Feed Motor
Safety surface for pressing
of the insert.
Switch PCB Ass'y
Main Chassis Ass'y (Bottom Side)
• Loosen the wire in the direction of the arrow.
B2-3
Rack Feed Ass'y
6.0 ± 0.2mm
~ FEED MOTOR ~
BLUE (4)
ORANGE (3)
~ SPINDLE MOTOR ~
BLACK (2)
RED (1)
• Install wire from (1) to (4) in order.
Check Hook
Check Hook
Check Hook
Check Hook
Fig. 2-7-B
Fig. 2-7-C
Fig. 2-7-D
Fig. 2-7-E
Advertisement
Table of Contents
