Asus Ez Flash 2 Utility - Asus E3746 Hardware User Manual

4.1.2

ASUS EZ Flash 2 utility

The ASUS EZ Flash 2 feature allows you to update the BIOS without having to
go through the long process of using a DOS-based utility. The EZ Flash 2 utility
is built-in the BIOS chip so it is accessible by pressing <Alt> + <F2> during the
Power-On Self Tests (POST).
To update the BIOS using EZ Flash 2:
1. �isit the ASUS website (www.asus.com) to download the latest BIOS file for
the motherboard.
2. Save the BIOS file to a USB flash disk, then restart the system.
3. You can launch the EZ Flash 2 by two methods.
(1) Insert the USB flash disk that contains the BIOS file to the USB port.
Press <Alt> + <F2> during POST to display the following.
(2) Enter BIOS setup program. Go to the Tools menu to select EZ Flash2
and press <Enter> to enable it.
You can switch between drives by pressing <Tab> before the correct file
is found. Then press <Enter>.
4. When the correct BIOS file is found, EZ Flash 2 performs the BIOS update
process and automatically reboots the system when done.
•
•
4-4
ASUSTek EZ Flash 2 BIOS ROM Utility B327
FLASH TYPE: Winbond W39V080A 8Mb LPC
Current ROM
BOARD: STRIKER II EXTREME
VER: 0106
DATE: 01/18/2008
PATH: A:\
A:
Note
[Enter] Select
[Tab] Switch
This function can support devices such as USB flash disk or hard disk with
FAT 32/16/12 format only.
Do not shut down or reset the system while updating the BIOS to prevent
system boot failure!
Update ROM
BOARD: Unknown
VER: Unknown
DATE: Unknown
[S] Save [ESC] Exit
[Up/Down/Home/End] Move
Chapter 4: BIOS setup