Asus E3746 Hardware User Manual page 71

For watercooling system with 1/2" or 10mm ID tubes
1. Insert a fitting (1/2" to 3/8" ID or 10mm to 3/8" ID) into the tube.
Your watercooling system may come with tube clamps. Use a clamp to fasten
the fitting and the tube together.
2. Connect a supplied 3/8" ID tube to the fitting.
3. Loosen the screw of a 1/2" ID tube clamp and hitch it to the bottom end of the
3/8" ID tube. Tighten the clamp screw with a screwdriver.
4. Hitch another clamp to the top end of the 3/8" ID tube.
1
5. Connect the assembled tube to the waterblock and tighten the screw of the
clamp using a screwdriver.
6. Repeat Step 1 to 5 for another tube. Make sure that both tubes are well
connected to prevent leak, and then fill the coolant into the reservoir.
5
ROG Striker II Extreme / Striker II NSE
2
3
6
4
2-45