AT&T TL92273 User Manual page 19

Appendix
Troubleshooting
Out of range OR Base no power appears on my cordless handset.
• Ensure you plug the telephone base in properly and the
power is on.
• Place the cordless handset in the telephone base for one
minute to allow the cordless handset and base to synchronize.
• Move the cordless handset closer to the telephone base. You
may have moved out of range.
• Reset the telephone base. Unplug the electrical power. Wait
for 15 seconds, then plug it back in. Allow up to one minute
for the cordless handset and telephone base to reset.
• Other electronic products such as HAM radios and other DECT
phones, can cause interference with your cordless phone. Try
installing your phone as far away as possible from these types
of electronic devices.
The batteries do not hold a charge.
• If the cordless handset is in the telephone base or charger
and the charge light is not on, refer to The charge light is off
(page 19).
• Charge the battery in the cordless handset for at least 11
hours. For optimum daily performance, return the cordless
handset to the telephone base or charger when not in use.
• If the battery is depleted, it may take approximately 30
minutes to charge the handset before it shows Low battery.
Refer to the table on page 6 for details.
You may need to purchase a new battery. Refer to Battery
•
installation and charging in this user's manual on pages 6-7.
I hear other calls while using my phone.
• Disconnect the telephone base from the telephone jack, and
plug in a different telephone. If you still hear other calls, call
your telephone service provider.
14