AT&T TL92273 User Manual page 12

Getting started
Battery installation and charging
Install the battery, as shown below.
Step 1
Plug the battery connector
securely into the socket
inside the handset battery
compartment. Insert the
supplied battery with the
label THIS SIDE UP facing
up, as indicated.
CHARGE light
After you install your telephone or power returns following a
power outage, the handset will prompt you to set the date and
time. For instructions, see Set date and time in the telephone
system user's manual for details. To skip setting the date and
time, press
IMPORTANT INFORMATION:
• Use only the supplied rechargeable battery or replacement battery (model
BT183342). To order, visit our website at
1 (800) 222-3111
or call
• If you do not use the handset for a long time, disconnect and remove the
battery to prevent possible leakage.
Step 3
Charge the handset by placing it
face up in the telephone base or
charger. The CHARGE light is on
when charging.
/CANCEL or BACK.
OFF
www.telephones.att.com
. In Canada, dial
7
Step 2
Align the cover
flat against
the battery
compartment, then
slide it upwards
until it clicks into
place.
1 (866) 288-4268
.