Table of Contents
Advertisement
The BIOS information in the above screen is for reference only. What you see
on your screen may not be exactly the same as shown.
2.1.2 Using AFLASH to update the BIOS
Creating a bootable disk
AFLASH.EXE is a Flash Memory Writer utility that updates the BIOS by uploading
a new BIOS file to the programmable flash ROM on the motherboard. This file
works only in DOS mode. To determine the BIOS version of your motherboard,
check the last four numbers of the code displayed on the upper left-hand corner of
your screen during bootup. Larger numbers represent a newer BIOS file.
1. Type FORMAT A:/S at the DOS prompt to create a bootable system disk. DO
NOT copy AUTOEXEC.BAT and CONFIG.SYS to the disk.
2. Type COPY D:\AFLASH\AFLASH.EXE A:\ (assuming D is your CD-ROM drive)
to copy AFLASH.EXE to the boot disk you created.
AFLASH works only in DOS mode. It does not work with certain memory drivers
that may be loaded when you boot from the hard drive. It is recommended that
you reboot using a floppy disk.
3. Reboot the computer from the floppy disk.
BIOS setup must specify "Floppy" as the first item in the boot sequence.
4. In DOS mode, type A:\AFLASH <Enter> to run AFLASH.
If the word "unknown" appears after Flash Memory:, the memory chip is either
not programmable or is not supported by the ACPI BIOS and therefore, cannot
be programmed by the Flash Memory Writer utility.
2-4
Chapter 2: BIOS Information
Hide quick links:
Advertisement
Table of Contents
