H Battery Installation - Power Wheels K7187 Owner's Manual With Assembly Instructions

Table of Contents

Advertisement

IMPORTANT! Use only a Power Wheels
battery and built-in thermal fuse. Use of any other battery will
damage your vehicle. Make sure that you charge the battery for
at least 18 hours using the enclosed Power Wheels
(4.0 Amp/Hr.) charger before operating your vehicle for the first
time. Charge the battery for at least 14 hours after each use of the
vehicle. Never charge the battery longer than 30 hours. Failure to
follow these instructions may damage your battery and will void
your warranty.
Seat
Unlocked
Lock
Fastener
1
• Locate the lock fastener in the back end of the seat.
• Using a slotted screwdriver, turn the lock fastener
unlocked position
.
• Lift the seat from the vehicle.
Battery
Retainer
2
• Loosen the screw in the battery retainer and remove it.
K7187pr-0726
BATTERY INSTALLATION
6 volt (4.0 Amp/Hr.)
®
6 volt
®
1
/
turn to the
4
6 Volt
Battery
3
• Fit the Power Wheels
6 volt (4.0 Amp/Hr) battery inside the battery
®
compartment with the wires facing towards the rear of the vehicle.
Battery
4
• Place the battery retainer over the battery.
• Replace the screw through the end of the battery retainer and into
the vehicle.
• Tighten the screw with a Phillips screwdriver. Do not over-tighten.
H
Battery
Compartment
Battery
Retainer
11
J7825a-0920

Advertisement

Table of Contents
loading

Table of Contents