Advertisement
Follow these steps to add a WPS-enabled device to the wireless network using
the WPS/WLAN button.
Set Up a Wireless Network Manually
The wireless LAN on your Device is enabled by default. To add a wireless client
to the network, use the settings found on the side panel of your Device, which
will look similar to the following example:
SSID: ZyXEL00561
Security Mode: WPA2-PSK
Pre-Shared Key: FB373BD356
Configure wireless devices that you want to connect to the wireless network to
use the same wireless settings as the Device.
The default wireless settings vary for each Device. Refer to the side panel
of your device and use the provided information.
VMG4380-B10A / VMG4325-B10A
Place the devices you want to connect near one
1
another.
Press the WPS button on the Device.
1
2
The WPS light blinks green and orange.
Press the WPS button on a compatible device
3
within 2 minutes of pressing the button on the
Device.
The WPS light on the Device shines steadily
when connected.
7
Advertisement
