Advertisement
1. Attach the antenna and point it up.
2. Do one of the following for your Internet connection:
a. DSL 1,2: Use a telephone cable to connect your Device's DSL1 port to a
telephone jack (or the DSL or modem jack on a splitter if you have one).
b. If the DSLAM at your ISP supports DSL bonding function, you can
connect DSL1 and DSL2 to two seperate telephone jacks. This provides
increased throughput at longer distances. You will need to access the
Web Configurator and enable the DSL Bonding function in the
Broadband > DSL screen. See the User's Guide for more information.
c. ETHERNET WAN: If you already have a broadband router or modem, use
an Ethernet cable to connect the ETHERNET WAN port to it for Internet
access.
3. ETHERNET: Use an Ethernet cable to connect a computer to an Ethernet
port for initial configuration and/or Internet access.
4. HPNA: (VMG4380-B10A only) Use a coaxial cable to connect to a coaxial
outlet and relay Internet traffic throughout your house through coaxial
cabling.
5. USB: Connect a USB (version 2.0 or lower) memory stick or a USB hard
drive for file sharing. Use a USB extension cable if the stick is too big to fit.
6. POWER: Use the provided power adaptor to connect the POWER socket to
an appropriate power source. Make sure the power at the outlet is on. After
connecting the power adaptor, look at the lights on the front panel.
• The POWER light blinks while your Device starts up and then stays on
once it is ready.
• Each LAN light stays on if the corresponding Ethernet port is properly
connected and blinks when there is traffic.
• The ETHERNET WAN light stays on if the ETHERNET WAN port is
properly connected and blinks when there is traffic.
VMG4380-B10A / VMG4325-B10A
5
Advertisement
