Slew Speeds; Observe The Moon; Astronomical Observing; To Track An Object Automatically - Meade DS-2000 Instruction Manual

Slew Speeds

NOTE:
Do not look through
Autostar has nine slew speeds that are directly proportional to the sidereal rate (see
the telescope's eye-
AN OBJECT AUTOMATICALLY
piece or viewfinder
ed to accomplish specific functions. Pressing the SPEED/? key changes the slew speed, which
while it is rapidly
is shown for about two seconds on Autostar's display.
moving. Children
The nine available speeds are:
should always have
adult supervision
while observing.
TIP: When a mes-
sage is scrolling
across the display,
press and hold the
Up Arrow key to
increase the scrolling
speed or press and
Speeds 1, 2, or 3: Best used for fine centering of an object in the field of view of a higher power
hold the Down Arrow
eyepiece, such as a 12mm or a 9mm eyepiece.
key to decrease the
Speeds 4, 5, or 6: Enables centering an object in the field of a low-to-moderate power eye-
scrolling speed.
piece, such as a standard 25mm eyepiece.
Speeds 7 or 8: Best used for rough centering of an object in the eyepiece.
Speed 9: Moves the telescope quickly from one point in the sky to another.

Observe the Moon

Point your telescope at the Moon (note that the Moon is not visible every night) and practice
using the Arrow keys and the slew speeds to view different features. The Moon contains many
interesting features, including craters, mountain ranges, and fault lines. The best time to view
the Moon is during its crescent or half phase. Sunlight strikes the Moon at an angle during these
periods and adds a depth to the view. No shadows are seen during a full Moon, causing the
overly bright surface to appear flat and rather uninteresting. Consider the use of a neutral den-
sity Moon filter when observing the Moon. Not only does it cut down the Moon's bright glare,
but it also enhances contrast, providing a more dramatic image.

Astronomical Observing

Used as an astronomical instrument, your telescope has many optical and electromechanical
capabilities. It is in astronomical applications where the high level of optical performance is
readily visible. The range of observable astronomical objects is, with minor qualification, limit-
ed only by the observer's motivation.

To Track an Object Automatically

As the Earth rotates beneath the night sky, the stars appear to move from East to West. The
speed at which the stars move is called the sidereal rate. You can setup your telescope to move
at the sidereal rate so that it automatically "tracks" the stars and other objects in the night sky.
If the telescope is not tracking an astronomical object, the object will drift out of the eyepiece
field of view. The tracking function automatically keeps an object more or less centered in the
telescope's eyepiece.
To automatically track objects, you must first set the telescope in the home position, then ini-
tialize Autostar, and finally select "Targets: Astronomical" from the Autostar Setup menu. You
must also learn how the Autostar keypad operates in order to move through the Autostar
menus.
below for a definition of "sidereal rate") and have been calculat-
Speed 1 = 2x =
Speed 2 = 8x =
Speed 3 = 16x =
Speed 4 = 32x =
Speed 5 = 64x =
Speed 6 = 0.5° = 120 x sidereal (30 arc-min/sec or 0.5°/sec)
Speed 7 = 1°/s = 240 x sidereal (60 arc-min/sec or 1°/sec)
Speed 8 = 2°/s = 480 x sidereal (120 arc-min/sec or 2°/sec)
Speed 9 = Max = (Maximum speed possible, dependent on battery power)
2 x sidereal (0.5 arc-min/sec or 0.008°/sec)
8 x sidereal (2 arc-min/sec or 0.033°/sec)
16 x sidereal (4 arc-min/sec or 0.067°/sec)
32 x sidereal (8 arc-min/sec or 0.13°/sec)
64 x sidereal (16 arc-min/sec or 0.27°/sec)
16
TO TRACK