Intex 24 Owner's Manual page 9

This pool may have been purchased with the Intex Krystal Clear™
filter-pump. The filter-pump has a separate set of installation instructions
and is to be set-up after assembling this unit.
1. • Find a flat, level location that is free and clear of stones, branches or other sharp objects
that may puncture the pool liner or cause injury.
• Open the carton containing the liner, joints, legs, etc., very carefully as this carton can be
used to store the pool during the winter months.
• Remove the ground cloth (10) and spread over the area cleared, and then remove the
liner (7) and spread it out over the ground cloth with the drain valve towards the draining
area. Place the drain valve away from the house. Allow the sun to warm up the liner
before inserting the beams (6) into the sleeve openings.
IMPORTANT: Do not drag the pool liner across the ground as this may result in
leaks or other damage (see drawing 1).
• During the set-up of this pool liner point
the hose connections or openings in the
direction of the electric power source. The
outer edge of the assembled pool is
to be within reach of the electrical
connection for the optional filter-pump.
2. • The frame pool's legs (8) and beams (6) fall into two groups. The larger diameters are
the horizontal beams that are slid (pushed) into the sleeve openings at the top of the
liner. The smaller diameters are the vertical legs. Both these legs and beams fit into the
T-joints (3).
• Starting at any location, but always working in the
same direction, push the horizontal beam into the
sleeve. Once the beam is centered take one of the
T- joints and using the connection pin (1), attach the
joint to one end of the beam by inserting the pin
through the seal (2) and in the pre-drilled holes.
Repeat this procedure in a circular fashion until all
the beams and joints have been connected
(see drawing 2.1).
The last joint connection may be difficult to
complete, but can be easily done by
simultaneously raising this last joint and beam
about 2 inches (5 cm), and inserting the beam
into the joint while lowering these pieces to
their normal position. The beam will slide into
the joint (see drawing 2.2). Make sure the last
joint is fully assembled before proceeding to
assembling the legs.
SAVE THESE INSTRUCTIONS
(87PO) ROUND METAL FRAME POOL ENGLISH 7.5" X 10.3" PANTONE 295U 06/27/2008
POOL SET UP (continued)
English
1
7
2.1
1
2
6
3
2.2
3
Page 9
87PO