Intex 24 Owner's Manual page 10

3. Next slide the vertical legs into the belt loop
located in the middle of the pool liner.
The bottom of the leg is to be "inside" the white
restraining rope (9) located near the liner's bottom
edge (Except 10' (305cm) and 12' (366cm) pool sizes).
Carefully slide the leg into the belt loop and place
the leg's bottom inside the rope and then insert the
top of the leg into the bottom of the joint. Snap this
leg into joint's holes by aligning the holes and the
spring-loaded pin. Attach the leg's end cap (5) to
the bottom of the leg (see drawings 3.1 & 3.2).
4. • Grab the frame pool's top beams in 2 – 3 locations and "shake"
the pool to be sure all the joints, legs and beams "fit into each
other". Check and ensure all pins are in position by pushing all
the pins downwards through the holes (see drawing 4.1).
• Pull gently, in an outward direction, at the bottom of the leg
making sure the leg is inside the restraining rope. The leg is
to end up in an upright vertical position.
5. For pool liner with hose connectors (16' (488 cm) & below pools), if pool was purchased
without a filter pump, use two of the three plugs (11) and plug them into the black filter
pump outlets from the inside of the pool so water will not run out while filling.
If pool was purchased with a filter pump, see Krystal Clear™ Filter Pump Manual
first and then go to step #6.
6. • Before starting to fill pool with water, check to be sure that the drain plug inside the pool
is closed and the drain cap on the outside is screwed on tightly. Fill the pool with no
more than 1 inch of water; and look to see if there is any noticeable difference in the
slope of the pool floor.
IMPORTANT: If the water in the pool flows to one side, the pool is not completely
level. Setting up the pool on unlevel ground will cause the pool to tilt resulting in
the sidewall material bulging. If the pool is not completely level, you must drain the
pool, level the area or move the pool to a different area that is level, and re-fill the
pool.
• Begin to smooth out the remainder of wrinkles (from inside pool) by pushing out where
the pool floor and pool sides meet, or (from outside pool) reach under the pool side,
grasp the pool floor and pull out. If the ground cloth is causing the wrinkles then have 2
adults pull from either side to remove all wrinkles.
7. Water may be filled just below the interior
welding sleeve line. (see drawing 4.2).
8. Aquatic Safety
Select a highly visible area near the pool to
post the Danger No Diving or Jumping sign
included later in this manual.
Before allowing anyone to use the pool, hold a family meeting and establish a
set of rules that include, at a minimum, the important safety rules and general
aquatic safety information in this manual. Review these rules on a regular basis
and with all users of the pool including guests.
SAVE THESE INSTRUCTIONS
(87PO) ROUND METAL FRAME POOL ENGLISH 7.5" X 10.3" PANTONE 295U 06/27/2008
POOL SET UP (continued)
IMPORTANT
English
3
8
9
3.2
3.1
5
WATER LEVEL
87PO
4
4.1
4.2
Page 10